Bandwidth Enhancement of Circular Structure Microstrip Antenna based on Inverted C-shaped Ground Configuration
Abstract
Designing microstrip antennas with wide bandwidth and low-frequency capabilities presents several challenges. These difficulties mainly arise due to the relatively small size of the microstrip in comparison to the operating frequency. Therefore, achieving a combination of enhanced bandwidth and lower-frequency cut-off becomes crucial to support a broad frequency range of communication technologies. This paper presents a method for enhancing the bandwidth of a circular microstrip antenna based on an inverted C-shaped ground configuration. The proposed method successfully creates an antenna with extended bandwidth while lowering the operating frequency. The antenna was simulated and then fabricated using an RO5880 duroid substrate with a relative permittivity of 2.2, a thickness of 1.575 mm, and a loss tangent of 0.0009. The simulation and measurement results demonstrate that the antenna can operate effectively within a wide frequency range of 3.5 GHz to 18 GHz. Additionally, utilizing this method enables the antenna to function at even lower frequencies and wider bandwidth without the need for additional dimensions.References
W. Hong et al., “Multibeam antenna technologies for 5g wireless communications,” IEEE Trans. Antennas Propag., vol. 65, no. 12, pp. 6231–6249, 2017, doi: 10.1109/TAP.2017.2712819.
T. Li and Z. N. Chen, “Shared-surface dual-band antenna for 5g applications,” IEEE Trans. Antennas Propag., vol. 68, no. 2, pp. 1128–1133, 2019, doi: 10.1109/TAP.2019.2938584.
W. Hong, K.-H. Baek, and S. Ko, “Millimeter-wave 5g antennas for smartphones: overview and experimental demonstration,” IEEE Trans. Antennas Propag., vol. 65, no. 12, pp. 6250–6261, 2017, doi: 10.1109/TAP.2017.2740963.
K. S. Radhakrishna, M. S. Shakhirul, Y. S. Lee, K. N. Khairina, and A. R. A. Syafiqah, “Investigate bending effect of wearable gps patch antenna with denim and polyester fabric substrate,” Int. J. Electron. Telecommun., vol. 69, no. 2, pp. 225–231, 2023, doi: 10.24425/ijet.2023.144354.
S. H. Hussein and K. K. Mohammed, “A dual-band compact integrated rectenna for implantable medical devices,” Int. J. Electron. Telecommun., vol. 69, no. 2, pp. 239–245, 2023, doi: 10.24425/ijet.2023.144356.
A. Ghodake and B. Hogade, “Wearable textile antenna for glucose level monitoring,” Int. J. Electron. Telecommun., vol. 69, no. 2, pp. 219–224, 2023, doi: 10.24425/ijet.2023.144353.
D. Liu, W. Hong, T. S. Rappaport, C. Luxey, and W. Hong, “What will 5g antennas and propagation be?,” IEEE Trans. Antennas Propag., vol. 65, no. 12, pp. 6205–6212, 2017, doi: 10.1109/TAP.2017.2774707.
I. Ahmad, W. Tan, Q. Ali, and H. Sun, “Latest performance improvement strategies and techniques used in 5g antenna designing technology, a comprehensive study,” Micromachines, vol. 13, no. 5, p. 717, 2022, doi: 10.3390/mi13050717.
J. Shi, X. Geng, S. Yan, K. Xu, and Y. Chen, “An approach to achieving multiple mutual coupling nulls in mimo stacked patch antenna for decoupling bandwidth enhancement,” IEEE Trans. Circuits Syst. II Express Briefs, vol. 69, no. 12, pp. 4809–4813, 2022, doi: 10.1109/TCSII.2022.3196020.
C. Lee, T. Yo, F. Huang, and C. Luo, “Bandwidth enhancement of planar inverted‐f antenna for implantable biotelemetry,” Microw. Opt. Technol. Lett., vol. 51, no. 3, pp. 749–752, 2009, doi: 10.1002/mop.24189.
Y. Cui, L. Wu, and R. Li, “Bandwidth enhancement of a broadband dual-polarized antenna for 2g/3g/4g and imt base stations,” IEEE Trans. Antennas Propag., vol. 66, no. 12, pp. 7368–7373, 2018, doi: 10.1109/TAP.2018.2867046.
K. Da Xu, H. Xu, Y. Liu, J. Li, and Q. H. Liu, “Microstrip patch antennas with multiple parasitic patches and shorting vias for bandwidth enhancement,” IEEE Access, vol. 6, pp. 11624–11633, 2018, doi: 10.1109/ACCESS.2018.2794962.
K. Saraswat and A. R. Harish, “Analysis of wideband circularly polarized ring slot antenna using characteristics mode for bandwidth enhancement,” Int. J. RF Microw. Comput. Eng., vol. 28, no. 2, p. e21186, 2018, doi: 10.1002/mmce.21186.
T. Ali, M. S. Aw, and R. C. Biradar, “AA compact bandwidth enhanced antenna loaded with srr for wlan/wimax/satellite applications,” Adv. Electromagn., vol. 7, no. 4, pp. 78–84, 2018, doi: 10.7716/aem.v7i4.644.
S. Das, A. Gupta, and S. Sahu, “Metamaterial based fractal-ground loaded frequency-reconfigurable monopole-antenna with gain-bandwidth enhancement,” AEU-International J. Electron. Commun., vol. 132, p. 153593, 2021, doi: 10.1016/j.aeue.2020.153593.
C. Sun, H. Zheng, L. Zhang, and Y. Liu, “Analysis and design of a novel coupled shorting strip for compact patch antenna with bandwidth enhancement,” IEEE Antennas Wirel. Propag. Lett., vol. 13, pp. 1477–1481, 2014, doi: 10.1109/LAWP.2014.2341596.
W. Chen, G. Wang, and C. Zhang, “Bandwidth enhancement of a microstrip-line-fed printed wide-slot antenna with a fractal-shaped slot,” vol. 57, no. 7, pp. 2176–2179, 2009, doi: 10.1109/TAP.2009.2021974.
W. X. Liu, Y. Z. Yin, W. L. Xu, and S. L. Zuo, “Compact open-slot antenna with bandwidth enhancement,” IEEE Antennas Wirel. Propag. Lett., vol. 10, pp. 850–853, 2011, doi: 10.1109/LAWP.2011.2165197.
A. Dastranj, F. Ranjbar, and M. Bornapour, “A new compact circular shape fractal antenna for broadband wireless communication applications,” Prog. Electromagn. Res. C, vol. 93, pp. 19–28, 2019, doi: 10.2528/PIERC19031001.
T. Addepalli and V. R. Anitha, “A very compact and closely spaced circular shaped uwb mimo antenna with improved isolation,” AEU-International J. Electron. Commun., vol. 114, p. 153016, 2020, doi: 10.2528/PIERC19031001.
D. Gopi, A. R. Vadaboyina, and J. R. K. K. Dabbakuti, “DGS based monopole circular-shaped patch antenna for uwb applications,” SN Appl. Sci., vol. 3, no. 2, p. 198, 2021, doi: 10.1007/s42452-020-04123-w.
Additional Files
Published
Issue
Section
License
Copyright (c) 2024 International Journal of Electronics and Telecommunications
This work is licensed under a Creative Commons Attribution-NonCommercial 4.0 International License.
1. License
The non-commercial use of the article will be governed by the Creative Commons Attribution license as currently displayed on https://creativecommons.org/licenses/by/4.0/.
2. Author’s Warranties
The author warrants that the article is original, written by stated author/s, has not been published before, contains no unlawful statements, does not infringe the rights of others, is subject to copyright that is vested exclusively in the author and free of any third party rights, and that any necessary written permissions to quote from other sources have been obtained by the author/s. The undersigned also warrants that the manuscript (or its essential substance) has not been published other than as an abstract or doctorate thesis and has not been submitted for consideration elsewhere, for print, electronic or digital publication.
3. User Rights
Under the Creative Commons Attribution license, the author(s) and users are free to share (copy, distribute and transmit the contribution) under the following conditions: 1. they must attribute the contribution in the manner specified by the author or licensor, 2. they may alter, transform, or build upon this work, 3. they may use this contribution for commercial purposes.
4. Rights of Authors
Authors retain the following rights:
- copyright, and other proprietary rights relating to the article, such as patent rights,
- the right to use the substance of the article in own future works, including lectures and books,
- the right to reproduce the article for own purposes, provided the copies are not offered for sale,
- the right to self-archive the article
- the right to supervision over the integrity of the content of the work and its fair use.
5. Co-Authorship
If the article was prepared jointly with other authors, the signatory of this form warrants that he/she has been authorized by all co-authors to sign this agreement on their behalf, and agrees to inform his/her co-authors of the terms of this agreement.
6. Termination
This agreement can be terminated by the author or the Journal Owner upon two months’ notice where the other party has materially breached this agreement and failed to remedy such breach within a month of being given the terminating party’s notice requesting such breach to be remedied. No breach or violation of this agreement will cause this agreement or any license granted in it to terminate automatically or affect the definition of the Journal Owner. The author and the Journal Owner may agree to terminate this agreement at any time. This agreement or any license granted in it cannot be terminated otherwise than in accordance with this section 6. This License shall remain in effect throughout the term of copyright in the Work and may not be revoked without the express written consent of both parties.
7. Royalties
This agreement entitles the author to no royalties or other fees. To such extent as legally permissible, the author waives his or her right to collect royalties relative to the article in respect of any use of the article by the Journal Owner or its sublicensee.
8. Miscellaneous
The Journal Owner will publish the article (or have it published) in the Journal if the article’s editorial process is successfully completed and the Journal Owner or its sublicensee has become obligated to have the article published. Where such obligation depends on the payment of a fee, it shall not be deemed to exist until such time as that fee is paid. The Journal Owner may conform the article to a style of punctuation, spelling, capitalization and usage that it deems appropriate. The Journal Owner will be allowed to sublicense the rights that are licensed to it under this agreement. This agreement will be governed by the laws of Poland.
By signing this License, Author(s) warrant(s) that they have the full power to enter into this agreement. This License shall remain in effect throughout the term of copyright in the Work and may not be revoked without the express written consent of both parties.